i.e. Banbury or similar. The following parameters are sought:

a/ Reduction ratio of between 1:10 to 1:20 or better.

b/ Output shafts of at least 10” (254mm) required.

c/ Counter rotating output shafts essential.

d/ Centre distance of shafts between 18”min. to 24”max. (457mm – 609.6mm max.) is required. Others will be considered.

e/ Single or 2 speed OK. Input horsepower up to 450 (170kw)

2/ Planetary gear reduction unit.

a/ Suitable to mount on driven shaft of 10”min. to 12”max. (254mm – 304.8mm) Either direct mount, or flange mounting considered.

b/ All ratios offered will be considered.

c/ Input shaft may be either direct mount or pinion mount.

d/ Condition required: In good operating order.

3/ Single output, double helical gear, reduction gear box.

a/ Output shaft of between 10”min. to 12”max. (254mm – 304.8)

b/ Input shaft of between 4”min. to 6”max. (100mm to 150mm)

c/ Ratio required between 5:1 min through to 1:50 acceptable.

d/ Condition expected: Good operating order.

Rebuild considered, depending on availability of spare parts.

Contact with offers: Bob Poll
Telephone: (+61 3) 9706 5443
Email: bobpoll@entyre.com.au

Capacity: Between 2 to 4 tons per hour.

Drive type: Hydraulic, helical gear, or planetary reduction.

Motor source: Either electric or diesel.

Auxiliary equip: Magnetic screening, vacuum system, & cyclones if available.

Condition: In good useable condition, right down to the point of requiring a full overhaul. Either condition acceptable.

Reply with offer: Attention Bob Poll.
Telephone: (+61 3) 9706 5443
Email: bobpoll@entyre.com.au